Electrical
#16
Banned






Joined: Mar 2008
Posts: 1,030











Protection is what you need any Electrical units Surge Protection !
#18
Banned






Joined: Mar 2008
Posts: 1,030











not at the plug but at the fuse board ....... where need to do the change and there not 100% if you read the small print
but so far keep all fingers crossed
foound it what comes down the phone line is what facks up pcs here
jurdy
Advertising in Doctor's Offices
I'm sure that you have seen pharmaceutical advertising in doctor's offices on everything from tissues to exam table cover paper. Well, in my book, this one should get the prize....
but so far keep all fingers crossed
foound it what comes down the phone line is what facks up pcs here
jurdy
Advertising in Doctor's Offices
I'm sure that you have seen pharmaceutical advertising in doctor's offices on everything from tissues to exam table cover paper. Well, in my book, this one should get the prize....
Last edited by jurdyr; Oct 20th 2008 at 4:14 am.
#20
Banned






Joined: Mar 2008
Posts: 1,030











One of our doctor buddies e-mailed back:
'If the light stays on for more than 4 hours, call your electrician.'
lol
'If the light stays on for more than 4 hours, call your electrician.'
lol
#22
BE Forum Addict






Joined: Jun 2005
Posts: 1,319











Insulating tape!!! You were lucky
our previous owner had wrapped sticking plasters over the joints
#23
Just Joined

Joined: Jun 2007
Posts: 20

i am trying to help the person who placed the thread .so if you want 30yrs experienced spark 16th/17th edition experience .can i have one problem at a time .or you could pay me hourly rate plus diesel .

oh! insulation tester will not give you calculation for cable size but a low resistence meter with R1+R2 readings would help with continuity and length of final circuit .L x vdp/am x load = volt drop
1000
oh! insulation tester will not give you calculation for cable size but a low resistence meter with R1+R2 readings would help with continuity and length of final circuit .L x vdp/am x load = volt drop

1000
#24
Banned






Joined: Mar 2008
Posts: 1,030











colin julie thanks for the Reply but thinks just go out the window here , again thanks for get back to what we sould be chatting about
jurdy
jurdy
#25
Colin julie and other helpful ones.
For a newbie this thread has been a real eye opener, so we are both very grateful for some very expert and helpful advice.
Thanks a million one and all!
For a newbie this thread has been a real eye opener, so we are both very grateful for some very expert and helpful advice.
Thanks a million one and all!




hat put a smile on my face HEHE
