TRA carpentry skills assessment
#1
Forum Regular
Thread Starter
Joined: Aug 2007
Posts: 134
TRA carpentry skills assessment
Hi everyone,
I was just wanting to know if anyone has done the workshop carpentry TRA skills assessment?
Is it hard to pass the test?
I have 1 and a half years experience plus 3 years training.
Thanks in advance.
I was just wanting to know if anyone has done the workshop carpentry TRA skills assessment?
Is it hard to pass the test?
I have 1 and a half years experience plus 3 years training.
Thanks in advance.
#2
Forum Regular
Joined: Sep 2008
Posts: 172
Re: TRA carpentry skills assessment
I am a chippy by trade, however I am employed as a Project Manager. If your a good chippy, you should sail through it.
Below is a rough guide of what to expect. You may also want to take a look here http://www.vetassess.com.au/download...date%20Kit.pdf
• Make a saw stool
• From designated specifications, set out pattern stud and wall plates and identify
scaffolding components
• Construct a pitch hip and gable roof
• Dress face of timber using surface planner
• Dress edge of timber using surface planner
• Rebate timber using static machine
• Rip timber to required size using rip saw
• Thickness timber to required dimensions using thicknesser
• Maintain static machines, surface planner, rip saw, thicknesser
• Use small plant and equipment
• Draw full size set out of panel door and window as per plan
• Construct bridle joint
• Construct mortise and tenon joint
• Make set outs
• Prepare set out rod
Best of luck.
Below is a rough guide of what to expect. You may also want to take a look here http://www.vetassess.com.au/download...date%20Kit.pdf
• Make a saw stool
• From designated specifications, set out pattern stud and wall plates and identify
scaffolding components
• Construct a pitch hip and gable roof
• Dress face of timber using surface planner
• Dress edge of timber using surface planner
• Rebate timber using static machine
• Rip timber to required size using rip saw
• Thickness timber to required dimensions using thicknesser
• Maintain static machines, surface planner, rip saw, thicknesser
• Use small plant and equipment
• Draw full size set out of panel door and window as per plan
• Construct bridle joint
• Construct mortise and tenon joint
• Make set outs
• Prepare set out rod
Best of luck.