|
Bathroom conversion
We are in the very early planning stage of replacing the bath in one or both of our bathrooms with walk-in showers. We never use the tub except to stand in for a shower so replacing it seems to be a no brainer. We have seen example projects in Leroy Merlin in Loule and the cost seems manageable.
Has anyone in CE done this? If so have you any hints or tips? Any drawbacks or unforeseen problems? Thanx for any advice. |
Re: Bathroom conversion
Originally Posted by MikeJ
(Post 12580481)
We are in the very early planning stage of replacing the bath in one or both of our bathrooms with walk-in showers. We never use the tub except to stand in for a shower so replacing it seems to be a no brainer. We have seen example projects in Leroy Merlin in Loule and the cost seems manageable.
Has anyone in CE done this? If so have you any hints or tips? Any drawbacks or unforeseen problems? Thanx for any advice. Jon. |
Re: Bathroom conversion
Try the bathroom show room Proveedora de la Costa Sil just south of Lepe they have displays and the products look a good quality and they may be able to direct you to a good fontanero |
Re: Bathroom conversion
Mike, I've been thinking of same in main bathroom of duplex on ME. My concern was when the bath tub comes out and the shower tray goes in you have to make good the tiling down to the tray. The pale green tiles look dated anyway IMO. Did to plan to retile the entire room with something more modern ?? If so I question if the old tiles will come off easily without breaking up the plasterboard ( dry lining) or whether you simply retile over the top???? A duplex on Manzana 2 had both bathrooms done last year and looking at the skip it seemed the builders replaced all the dry lining. The old tiles were still attached to the plasterboard that had been ripped out. Quite a lot of work to do oneself I think.
|
Re: Bathroom conversion
Originally Posted by MikeJ
(Post 12580481)
We are in the very early planning stage of replacing the bath in one or both of our bathrooms with walk-in showers. We never use the tub except to stand in for a shower so replacing it seems to be a no brainer. We have seen example projects in Leroy Merlin in Loule and the cost seems manageable.
Has anyone in CE done this? If so have you any hints or tips? Any drawbacks or unforeseen problems? Thanx for any advice. |
Re: Bathroom conversion
Make the cubicle as big as possible. Often it is better to get a builder to build one rather than buying a cubicle. If your water pressure is not high, think about getting a pump put into the supply so you get a really powerful jet. A friend has just put one in and it is big enough to have a built in seat to cater for the time when you will need to shower sitting down. It will come to us all eventually! |
Re: Bathroom conversion
Originally Posted by keithBT
(Post 12580602)
Mike, I've been thinking of same in main bathroom of duplex on ME. My concern was when the bath tub comes out and the shower tray goes in you have to make good the tiling down to the tray. The pale green tiles look dated anyway IMO. Did to plan to retile the entire room with something more modern ?? If so I question if the old tiles will come off easily without breaking up the plasterboard ( dry lining) or whether you simply retile over the top???? A duplex on Manzana 2 had both bathrooms done last year and looking at the skip it seemed the builders replaced all the dry lining. The old tiles were still attached to the plasterboard that had been ripped out. Quite a lot of work to do oneself I think.
I'm not planning a DIY but will get a man in. I have some experience of tanking a shower room and I wouldn't know where to start sourcing the specialist bits. Looks like I might need a bigger budget 🤔 |
Re: Bathroom conversion
Originally Posted by Fred James
(Post 12580636)
Make the cubicle as big as possible. Often it is better to get a builder to build one rather than buying a cubicle. If your water pressure is not high, think about getting a pump put into the supply so you get a really powerful jet. A friend has just put one in and it is big enough to have a built in seat to cater for the time when you will need to shower sitting down. It will come to us all eventually! |
Re: Bathroom conversion
Mike, For what it's worth, I rejigged my kitchen using the same units plus a new carcase for a eye level oven. I retiled over the top of the old tiles very sucessfully. I bought the tiles at the polygono tile warehouse and the proper fixing cement for going on top old tiles. Cement was 4 times the price of the cheap stuff at about 16 euros a bog. - BUT it works !! PS. If the apartment opposite has a couple of kitchen base unit doors they are ditching - would you mind grabbing them !!!! ( circa 50/55mm wide). I'm out next month.
|
Re: Bathroom conversion
Originally Posted by MikeJ
(Post 12580652)
Good point Fred about the seat. I am thinking wet room approach rather than cubicle at the moment.
|
Re: Bathroom conversion
Originally Posted by EsuriJohn
(Post 12580621)
My hint and tip is to speak to Esuri John he can give you great leads show you examples of workmanship and recommend places to get products. Done a similar project myself kept cost low and quality very high! Looking for a new career in politics John? Jon :) PS I once tanked out a walk in shower, and used lead, also it needed a professional plumber. But it was pricey. I believe there are newer merhods now (it was over 20 years ago). PPS Though Ive never done it, I've seen specialist tile paint for bathrooms used to good effect on home renovation prorgammes |
Re: Bathroom conversion
Not sure where you would get them in Spain, but you can buy acrylic sheet shower panels here on the UK from many companies that are tongue and grooved . They are completely waterproof and would just be stuck over the existing tiles. They come in loads of colours too.
|
Re: Bathroom conversion
Originally Posted by shirley and anthony hide
(Post 12580806)
Not sure where you would get them in Spain, but you can buy acrylic sheet shower panels here on the UK from many companies that are tongue and grooved . They are completely waterproof and would just be stuck over the existing tiles. They come in loads of colours too.
https://www.interiorpanelsystems.co....s-1000mm.html/ there are other makes and I think this is the cheaper end of the market but you can get almost any finish in U.K. My son in law (plumber) uses them in conversions from bath to walk in shower for the elderly. I think you might have two problems putting them over tiles 1) the surface would not be even to the floor where the bath has been removed and 2) you might get interstitial condensation behind the panel which could be a breeding ground for mould and we all know how difficult that can be in our winter climate here. The Spanish have been tiling for centuries so they know a thing or two about finishes. |
Re: Bathroom conversion
Originally Posted by EsuriJohn
(Post 12580846)
Have a look at this website:- https://www.interiorpanelsystems.co....s-1000mm.html/ there are other makes and I think this is the cheaper end of the market but you can get almost any finish in U.K. My son in law (plumber) uses them in conversions from bath to walk in shower for the elderly. I think you might have two problems putting them over tiles 1) the surface would not be even to the floor where the bath has been removed and 2) you might get interstitial condensation behind the panel which could be a breeding ground for mould and we all know how difficult that can be in our winter climate here. The Spanish have been tiling for centuries so they know a thing or two about finishes. |
Re: Bathroom conversion
Originally Posted by Fred James
(Post 12580636)
Make the cubicle as big as possible. Often it is better to get a builder to build one rather than buying a cubicle. If your water pressure is not high, think about getting a pump put into the supply so you get a really powerful jet. A friend has just put one in and it is big enough to have a built in seat to cater for the time when you will need to shower sitting down. It will come to us all eventually! You took the words right out of my mouth - I had my bath taken out and a 3 metre by one metre shower to replace it. When the time comes then a proper shower chair will be purchased and stored at the other end of the shower. My water is pumped from the well so that was OK but the fall of the water needs to be thought out and for that reason, I step up four inches to get into the shower. Davexf |
Re: Bathroom conversion
Hi Mike, we we have a 3 bed town house on lomas, and decided to re do the bathroom in our on suite about a year ago, used a local Spanish guy, who worked on the original Esuri site back in the day. He done a great job all back to the boards and resited the shower plus a full re tile walls n floor see below. Ken.https://cimg5.ibsrv.net/gimg/british...ce0f47d35.jpeghttps://cimg9.ibsrv.net/gimg/british...dbd935350.jpeg https://cimg2.ibsrv.net/gimg/british...3ccb6422f.jpeg https://cimg4.ibsrv.net/gimg/british...6b1586400.jpeg |
Re: Bathroom conversion
Aw shucks Ken after I had shown Mike our 1/2 bathroom I was going to come round to your house with a couple of bottles and ask if he could see your conversion. Only when you are in residence of course!👠|
Re: Bathroom conversion
Hi - Teed up, Looking at the pictures that is a really impressive job you have had done on your bathroom. That looks a high quality job done. How long did this take to complete & may I ask roughly what the total cost was ? feel free to PM me if you prefer.
|
Re: Bathroom conversion
Hi Keith, we we wanted a full makeover, and as usual the wife went overboard on the tiles and fittings??, so cost wise it’s down to the quality you want putting in the room?. We paid the fitter a day rate and he took about 5/6 days, but we also had the bath moved into the other bathroom and the sink taken out the other bathroom and two new sink cabinets fitted in the other bathrooms, all the tiles were from Porcelansa in Huelva not cheap but fantastic finish. Ken. |
Re: Bathroom conversion
Teed Up...………………â� ��¦.I have PM´d you.
Rosemary |
Re: Bathroom conversion
Originally Posted by Teed Up
(Post 12581442)
Hi Mike, we we have a 3 bed town house on lomas, and decided to re do the bathroom in our on suite about a year ago, used a local Spanish guy, who worked on the original Esuri site back in the day. He done a great job all back to the boards and resited the shower plus a full re tile walls n floor see below. Ken.https://cimg5.ibsrv.net/gimg/british...ce0f47d35.jpeghttps://cimg9.ibsrv.net/gimg/british...dbd935350.jpeg https://cimg2.ibsrv.net/gimg/british...3ccb6422f.jpeg https://cimg4.ibsrv.net/gimg/british...6b1586400.jpeg Looks like a fantastic job. ðŸ‘👠Jon PS did you tank out with lead, or something else? |
Re: Bathroom conversion
Originally Posted by Jon-Bxl
(Post 12581666)
Wot...... No bidet? ,,😙ðŸ˜
|
Re: Bathroom conversion
No, had them taken out of the two bathrooms and out of the apartment, get in the way !!. ken. |
Re: Bathroom conversion
We took out both bidets. We didn't feel the need to wash our feet separately !! Ho Ho.
|
Re: Bathroom conversion
Originally Posted by Teed Up
(Post 12581809)
No, had them taken out of the two bathrooms and out of the apartment, get in the way !!. ken. Of course... But for your walk in shower did you tank it in lead? Or did you do another method? Hope to see it over a beer sometime soon. Jon |
Re: Bathroom conversion
Originally Posted by Jon-Bxl
(Post 12581875)
Hi Ken
Of course... But for your walk in shower did you tank it in lead? Or did you do another method? Hope to see it over a beer sometime soon. Jon No lead, no zinc, no bitumen!i |
Re: Bathroom conversion
Originally Posted by MikeJ
(Post 12582540)
When l tanked our ensuite shower in the UK - and it was on the first floor so had to be A OK - I used preformed waterproof tray and wall boards. The boards were fixed over the existing tiles using special screws and gaskets then the joins between the corners and with the tray sealed with specialist tape and adhesive. Then as belt and braces I stuck waterproof membrane throughout out and then tiled over all and used acrylic grout. So far so good.
No lead, no zinc, no bitumen!i Things have changed since I did it - a couple of decades ago. We used sheets of lead, soldered where necessary and then tiled over, so the tiled floor continued 'invisibly' into the shower... which is a walk in (or Italian) shower for me. Hope to see you both soon Jon |
| All times are GMT -12. The time now is 8:35 pm. |
Powered by vBulletin: ©2000 - 2026, Jelsoft Enterprises Ltd.
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.